E-posformaatfout
emailCannotEmpty
emailDoesExist
pwdLetterLimtTip
inconsistentPwd
pwdLetterLimtTip
inconsistentPwd
Features: slag holes are open or closed holes in the casting. All or part of the holes is filled with molten slag. The shape is irregular, and the small dot flux slag inclusion is not easy to find. After the slag is removed, it presents smooth holes, which are generally distributed in the lower part of the pouring position, near the gate, or at the dead corner of the casting. The oxide slag inclusion is mostly distributed in a network on the surface of the casting near the gate, sometimes in the form of thin sheets or irregular clouds with wrinkles, Or form lamellar interlayer, or exists in the casting in the form of flocculent mass. When it is broken, it is often broken from the interlayer, in which oxide is one of the root causes of casting cracks.
Cause of formation: slag holes are mainly caused by alloy smelting process and pouring process (including incorrect design of pouring system). The mold itself will not cause slag holes, and metal mold is one of the effective methods to avoid slag holes.
Features: the appearance of the crack is a linear or irregular curve. The surface of the hot crack fracture is strongly oxidized and appears dark gray or black, without a metallic luster. The surface of the cold crack fracture is clean and has a metallic luster. Generally, the external cracks of castings can be seen directly, while the internal cracks can be seen only with the help of other methods. Cracks are often associated with shrinkage porosity, slag inclusion, and other defects, which mostly occur on the inner side of sharp corners of castings, at the junction of thick and thin sections, and in the hot spot area where the pouring riser is connected with the casting.
Cause of formation: the metal mold casting is easy to produces crack defects, because the metal mold itself is not yielding, and the cooling speed is fast, which is easy to cause the internal stress of the casting to increase, and the mold is opened too early or too late, the pouring angle is too small or too large, the coating layer is too thin, etc., which are easy to cause the casting to crack, and the mold cavity itself is also easy to cause cracks.
Features: cold shuts are a kind of through cracks or surface cracks with round edges, which are separated by oxide skin in the middle and are not completely integrated. When the cold shuts are serious, it becomes "undercast". Cold shuts often appear on the top wall of castings, thin horizontal or vertical planes, thick and thin wall connections, or thin auxiliary plates.